Walking tractor guide

When the tractor is working on the farmland, it is easy to run away. At this time, not only is the operation difficult, but also the wear of the related parts is accelerated and the quality of the work is seriously affected. Therefore, we should pay attention to it and pay attention to prevention.

1. Plowing

Hand tractor tractor unidirectional double plow operation. The driving wheel on one side is not on the arable land. The other side of the drive wheel in the furrow. The coefficient of adhesion between the two wheels and the ground is different, and the slip ratio varies, causing the crew to drift in one direction. In the process of ploughing, if the tractor is still found to be driving to the right, you can loosen the two fastening screws, rotate the extension of the left adjustment screw, and rotate the extension of the right screw. Until the armrests are released, the unit can travel normally along the trench walls.

2. Rotary work

Possible causes of biased driving during rotary tillage operations: rear wheels are deformed, the tail shaft is not assembled in the fork and the tail wheel is deflected: the bearings on the tail shaft are damaged or severely worn: the coulter is loaded wrongly or broken, dropped . When deviation phenomenon occurs in rotary tillage operation, related parts should be corrected, repaired, reinstalled or replaced according to specific conditions. Before the problem is solved, steering clutch correction should be avoided as much as possible. Instead, use the method of pushing and pulling the handrail frame to correct the deviation.

3. Sowing operation

When using a tractor for sowing. It can be equipped with a small corn planter or wheat planter, with complete functions, with ditching, seeding, fertilizing and other functions, simple structure, high seeding efficiency, and low loss rate. Before planting, apply lubricating oil to the planter, and simply adjust the machine to facilitate planting of crops.

4. Harvesting

Walking tractors are mainly equipped with small reaper harvesters. The main reason for unit deviation is that the cutting clearance of the harvester varies in the cutting direction. The cutting resistance is different: the side of the cutting knife is high and low, the cutting height is different when harvesting, and the working resistance is not equal; the cutting width is not properly selected; the ground is uneven. The corresponding measures should be taken for specific reasons.